Tubing Connectors and Fittings
Chemglass Life Sciences 24/40 Quartz Inner Joint, Full Length, 22.0mm/Tubing O.D.
24/40 Quartz Inner Joint, Full Length, 22.0mm/Tubing O.D. Clear fused quartz inner joints in medium and full length.
Bellco Glass, Inc. Freeze-Dry Ampoule.5mL Constriction on neck
Type 1 class a Borosilicate glass for freeze drying or cryogenic storage. The neck has pre-drawn constriction to facilitate sealing.. MADE IN THE USA Flat bottom Constriction neck Neck od: 6mm Bottom od: 4mm Capacity: 5ml Length: 105mm
Ace Glass, Inc. 18/9 ball joint, stainless steel, 1/4" male NPT
18/9 ball joint, fabricated from 18-8 type 303 stainless steel, is fully interchangeable with ACE glass joints, and has same size I.D. Shank is machined to 1/4 male NPT.
Chemglass Life Sciences Joint, Outer, # 38, Flask Length, 45 x 2.0mm
Joint, Outer, # 38, Flask Length, 45 x 2.0mm. Standard taper flask length joints, both inner and outer member. Part number CG-125-09 is used as a replacement neck for two liter Squibb style separatory funnels.
Ace Glass, Inc. 34/45 INNER JOINT (GB)
34/45 standard taper inner member ground joint for use with ACE 7565, 7566, 7567, 7651 and 7652 outer members. May also be used with ACE 7568 and 7585 half joints.
Chemglass Life Sciences 29/42 Outer Joint, 32mm X 2.4W Tubing
29/42 Outer Joint, 32mm X 2.4W Tubing. Standard taper outer joint tooled on tubing approximately the same diameter as the top reinforcing ring, affording no hold-up below joint.
Chemglass Life Sciences 19/38 Side Seal Joints, Sidearm OD: 10.0mm, Hole Size: 4mm
19/38 Side Seal Joints, Sidearm OD: 10.0mm, Hole Size: 4mm. Outer joint having a tubulation sealed at the midpoint of the ground portion, and a corresponding hole drilled in the inner joint permitting venting of the side tube when the inner joint is turned to the proper position.The 19/38 sizes are compatible with Buchi Rotary Evaporators. Part number CG-132-02 has a single sidearm and a drip tip permitting the seal to be made for the PTFE feed tube.
Chemglass Life Sciences 55/50 Inner Joint, Un-Cut Drip, on 51mm OD x 2mm W tubing
55/50 Inner Joint, Un-Cut Drip, on 51mm OD x 2mm W tubing. Drip tip. Joints are available uncut or with the drip tip being cut at a 45º angle. Tooled on the same tubing sizes as the CG-100 inner joints.
Chemglass Life Sciences 24/40 Outer Joint, 12in OAL, on 28mm OD x 2mm W tubing
24/40 Outer Joint, 12in OAL, on 28mm OD x 2mm W tubing. Standard taper inner and outer lengths tooled on longer lengths or different sizes than normally available under part numbers CG-100 through CG-105. These joints offer the glassblower the opportunity to construct apparatus made of heavier tubing or without unnecessary seals.